Wall Lights for Living Room: Height, Spacing and Material
How high, how far apart, which material: every measurement for wall lights above the sofa, beside the TV, in the hallway and by the bed, with a handy table.

Fit wall lights for the living room so that their centre sits 160 to 180 cm above the finished floor: just above standing eye level, so you don’t look straight into the bulb. Above the sofa, 150 to 170 cm is enough; in the hallway, 170 to 190 cm is usual, and on the stairs 180 to 200 cm above the edge of the step. Place two wall lights as a symmetrical pair, with 10 to 30 cm of space to the edge of the mirror, picture or TV.
How high should wall lights for the living room be?
A standing adult’s eye level is about 150 to 170 cm. If the light source sits just above it, your eye lands on the shade, stone or glass rather than the bare LED. When you sit, your eyes are at about 110 to 120 cm, which is why wall lights at 160 to 180 cm feel pleasantly high and glare-free from the sofa.
Measure from the finished floor to the centre of the light. If the wall plate isn’t centred, as with a gooseneck, use the dimensions in the product description to work back to the wiring point. These values apply to a ceiling height of about 2.50 m. With period-home ceilings from about 2.80 m, go 10 to 20 cm higher or choose a longer light.
Wall light height: where at what height? The guide values in a table
These guide values apply to a ceiling height of about 2.50 m and adults between 1.65 and 1.85 m tall. Our living room wall lights collection shows suitable models.
| Location | Fitting height (centre of light from floor) | Spacing and position |
|---|---|---|
| Living room, mood light | 160–180 cm | at least 40–60 cm from room corners and door frames |
| Above the sofa | 150–170 cm (bottom edge 25–30 cm above the seated head) | as a pair, each 20–40 cm inside the ends of the sofa, projection up to approx. 12 cm |
| Reading light beside a sofa or armchair | bottom of shade 110–140 cm | to the side, behind the shoulder, adjustable head |
| Beside the TV | roughly level with the top edge of the screen | 20–40 cm to the side of the screen |
| Above a sideboard or fireplace, beside a mirror or picture | 60–90 cm above the top of the furniture, usually 140–170 cm | as a pair, 10–30 cm outside the edge of the mirror or picture |
| Uplight or up & down | 160–180 cm | top edge at least 40–60 cm below the ceiling |
| Hallway | 170–190 cm | every 2–3 m, first light 50–100 cm after the door |
| Stairs and stairwell | 180–200 cm above the front edge of the step | every 2–3 m along the stairs |
| Bedroom, by the bed | 100–130 cm (approx. 45–70 cm above the mattress) | centred above the bedside table |
Beside the TV, choose light that stays on the wall so it doesn’t reflect in the screen. If two lights frame a mirror, their light should graze the frame rather than shine into the glass from the front. For the reading corner, there are dedicated wall reading lights with an adjustable head.
By the bed, a bedroom wall light hangs lower, because you use it sitting up. Read more in our guide how to light your bedroom; whether a wall light or a table lamp suits you better is covered in how to choose a bedside lamp.
Collection · 253 designsLiving Room Wall LightsView all 253 designs
How high should a wall light be above the sofa?
The back of a sofa is usually 75 to 90 cm high, and a seated adult’s head reaches about 120 to 130 cm. The bottom edge of the light sits 25 to 30 cm above that, so nobody knocks it when they stand up. That gives 150 to 170 cm for the centre of the light. Choose flat models with a projection of no more than about 12 cm; a shade sticking far out above the back of the sofa becomes an obstacle.
You have two options for the layout: two lights, each 20 to 40 cm inside the ends of the sofa, so 140 to 180 cm apart on a 220 cm sofa. Or a horizontal light bar centred above it, half to two-thirds the width of the sofa.
ESPEN is a bar of light-coloured wood with integrated LED, 60, 80 or 100 cm long and only 4 cm high; the 100 cm version fits above a 2 m sofa. ANKA is a travertine bar just 2.5 cm wide, 55 or 90 cm tall, with indirect light, which works as a vertical pair beside a bookcase or TV wall. MIRJA, a marble cylinder 6 cm in diameter and 40 to 80 cm long, projects only 10.5 cm from the wall. BELBA, made of staggered rods of genuine alabaster, measures 20 × 45 cm and remains a wall sculpture above the sideboard even when it is switched off.
What is the right spacing between two wall lights?
- As a pair: symmetrical about the centre line of the sofa, sideboard, mirror or TV, with the distances from the table. Check with a spirit level or line laser that both sit at exactly the same height.
- In a row: 2 to 3 m between the lights. The closer they are, the more the beams merge into a band; the further apart, the more distinct the pools of light.
- From corners and door frames: at least 40 to 60 cm, so the light can fan out.
- From the ceiling: with upward light, leave 40 to 60 cm clear, or you get a harsh bright patch instead of a soft fan.
In hallways narrower than 1.20 m, the projection matters too: you will find flat models among our hallway wall lights. For the height of a wall light on the stairs, measure from the front edge of the step below, not from the floor.
Up & down, indirect or directional: what light should the wall light give?
With wall lights for the living room and hallway, there are five light directions:
- Uplight: brightens the ceiling and makes the room feel taller. This is classic indirect wall lighting for the living room.
- Downlight: highlights whatever is below, such as a sideboard, plant or armchair.
- Up & down: two beams draw a vertical line on the wall; in pairs beside a fireplace or TV, the effect is architectural.
- All-round glow: opal glass and alabaster glow themselves and look best dimmed.
- Adjustable: a spotlight or shade on a joint for reading and accent light.
Slim cylinders work well for up & down light in natural stone. FRIDA is a travertine cylinder 6.5 cm in diameter, 28 or 32 cm tall, on a wooden plate, with G9 LEDs included. BOKI pairs a 32 cm travertine cylinder with solid wood in a walnut tone and two E27 lamp holders. PACHO, in Viola Calacatta marble, is 24 cm tall, projects only 9 cm from the wall and is dimmable with dimmable bulbs. NOSCA, in aluminium, is only 4 cm deep, comes in six widths from 8 to 32 cm and is also available in warm white at 3000 K, ideal for narrow hallways.
Plug-in or hardwired wall light: which is better?
A hardwired wall light needs a wiring point in the right place, and a qualified electrician makes the connection. In return, the cable stays hidden and the light runs off a wall switch. A plug-in wall light is also screwed to the wall, but its cable runs to the nearest socket: no electrician, no channel cut into the wall, ideal for rented homes and the reading corner. Plug-in wall lights are popular in the bedroom too, because they keep the bedside table free.
| Criterion | Plug-in | Hardwired |
|---|---|---|
| Installation | screw on, plug in | wiring point, qualified electrician |
| Cable | visible down to the socket | hidden in the wall |
| Switch | on the cable or on the light | wall switch |
| Ideal for | rented homes, reading corner, bedside | new builds, renovations, pairs above furniture |
Check the cable length: if the light hangs at 160 cm and the socket sits 30 cm above the floor, the vertical run alone uses around 120 to 130 cm. CORI has a 150 cm cable with a switch, a dark solid wood wall plate (18 × 28 cm) and a frosted glass globe. TINE has a 1.8 m cable and a ribbed glass flower 12 cm in diameter on a gooseneck. TUVA carries a ceramic shade 23 cm in diameter on a swivelling wooden arm. With TEIJA, only the model with the high arch (51 cm) comes with a plug. All models: plug-in wall lights.
Which material works: marble, travertine, alabaster, wood or glass?
Opaque materials direct the light up, down or onto the wall. Translucent materials glow themselves.
Marble wall lights
Marble is a dense natural stone whose veins run differently in every piece. Ground thin, it lets light through and the veins stand out against the light; cut thick, it stays opaque. MINA is a thin disc of genuine white marble with grey veining, Ø 20, 25 or 30 cm, with an LED behind it that draws a warm white halo on the wall.
Natural stone or marble effect?
If the material description says “marble effect” or “stone effect”, the light is an imitation made from another material. One example is SOLVI, with two marble-effect domes on a lacquered iron bracket. Imitations are lighter and more evenly patterned. Genuine natural stone is heavier, and the grain and translucency vary from light to light. So always read the “Materials” line in the product description. We bring together our genuine stone models under travertine and stone wall lights.
Travertine and alabaster
Travertine is a porous limestone in beige and sand tones and lets practically no light through. That is why travertine models shine up and down, through opal glass or with LEDs behind the stone: FALK is a travertine disc of Ø 18, 25 or 28 cm that creates a soft halo behind it. Alabaster, on the other hand, is highly translucent and glows from within. JILVA is carved from a solid block of alabaster, Ø 15 to 25 cm, at 3000 K. ZILA is a monolith of genuine alabaster measuring 65 × 16 × 10 cm that frames a sideboard as a pair. More shapes: alabaster wall lights.
Collection · 71 designsTravertine & Stone Wall LightsView all 71 designs
Wood, glass and metal
Wood doesn’t glow itself; it frames the light. A wooden wall light for the living room brings warmth to pale walls and suits Japandi and Scandi rooms. Wooden lights with a lamp holder call for LED bulbs, because they barely get warm. LAURI is a compact reading light with a wooden arm and a tilting metal shade (Ø 12 cm), bulb included. KYLA combines ash wood and glass in a flat disc 28 cm in diameter. ALTO has a faceted walnut shade (16 × 17 cm) and projects around 20 cm from the wall, so it belongs beside the armchair rather than in a narrow hallway. You will find more models among our wooden wall lights.
Opal glass spreads the light evenly without glare: OLAN carries an opal glass globe 20 cm in diameter, is 35 cm tall and comes in black or gold. Clear or fluted glass sparkles and shows the bulb; metal shades focus the light for reading. More among our glass wall lights.
How do you combine wall lights with a ceiling light and floor lamp?
A wall light is rarely the only light in a living room. The ceiling light provides general light from above, the floor lamp gives reading light at seat height, and the wall light fills the zone in between. Only these three layers make a room feel homely in the evening.
- Spread them out: the floor lamp, wall lights and table lamp form a triangle in the room rather than standing in one corner.
- Switch separately: put the ceiling light and wall lights on their own switches, and leave the ceiling off in the evening.
- One colour temperature: 2700 to 3000 K for every light in the room.
- One metal finish: repeat gold, brass or black in two or three places, and use no more than two kinds of stone per room.
- Brightness: about 200 to 400 lumens per wall light for mood light, 400 to 600 lumens for reading. Dimmable wall lights keep you flexible.
How big the ceiling light should be is explained in ceiling lights for the living room: size and brightness. Which floor lamp suits the sofa is covered in our guide to floor lamps for the living room, and the overall plan in how to light your living room.
What are the most common mistakes with wall lights?
- Fitted too low: below 150 cm you look into the light when standing, and above the sofa people bump into it.
- Uplight too close to the ceiling: with less than 40 cm of clearance, you get a harsh bright patch.
- Too much projection in the hallway: a shade sticking out 20 cm into a 1 m wide hallway gets brushed constantly.
- Wiring point without a furniture plan: plan the position from the furniture dimensions before filling and painting.
- Heavy stone, wrong wall plug: in plasterboard you need cavity wall fixings rated for the weight.
- Mixed colour temperatures: a cool white wall light next to warm white floor lamps ruins the mood.
Frequently asked questions
How high should a wall light be in the living room?
In the living room, the centre of the wall light sits 160 to 180 cm above the floor, just above standing eye level. Above the sofa, 150 to 170 cm is enough. With ceilings from about 2.80 m, you can go 10 to 20 cm higher.
How far apart should two wall lights be?
A pair hangs symmetrically: 10 to 30 cm outside the edge of a mirror or picture, 20 to 40 cm beside the TV, and above the sofa each 20 to 40 cm inside the ends. In a row along a hallway, allow 2 to 3 m between them.
How high should a wall light be above the bed?
By the bed, the centre of the light sits at about 100 to 130 cm above the floor, so 45 to 70 cm above the mattress. That way you can read sitting up without looking into the light source.
Can I fit a wall light without an electrician?
Yes, if it has a plug: screw it on and plug the cable into the nearest socket. Hardwired wall lights need a wiring point, and a qualified electrician makes the connection.
Is a wall light with a marble pattern always made of real marble?
No. If the material description says “marble effect” or “stone effect”, it is an imitation. Real marble is heavier, and every light has its own grain.
Which colour temperature suits living room wall lights?
In the living room, warm white at 2700 to 3000 K is right. Use this colour temperature for every light in the room, so that wall, floor and ceiling lights come together into a calm overall picture.
How high should a wall light be in a stairwell?
In a stairwell, measure from the front edge of the step below and set the centre of the light at 180 to 200 cm. Plan one light about every 2 to 3 m and choose flat models.






















